The Water Heater Guide

Types & choosing

Boiler vs Water Heater: What's the Difference?

Updated November 19, 2026By the The Water Heater Guide editorial team
Boiler vs Water Heater

In a boiler vs water heater comparison, the difference is the job. A boiler heats water for radiators, baseboards or radiant floors, while a water heater supplies hot water to your taps and appliances. Combi boilers do both jobs, and indirect water heaters are tanks fed by a boiler. Radiators, a storage tank and pipe count tell you which you have.

Space heating and domestic hot water are two separate jobs

Space heating warms the rooms in your home. In a hydronic (water-based) system, a boiler heats water and pumps it through radiators, baseboard units or tubing under the floor. The water gives up its heat to the room and returns to the boiler to be reheated.

Domestic hot water is the water you use at the tap for showers, dishes, laundry and handwashing. It runs on demand every day of the year, while space heating usually runs only in the cold months. That difference in schedule is one reason many homes use separate equipment for each job.

If your home has forced-air vents and no radiators or baseboard units, the heat probably comes from a furnace, not a boiler. The hot water in that case usually comes from a standalone water heater.

Combi boilers: one unit, two jobs

A combi boiler, also called a combination boiler, heats water for the heating loop and also heats tap water when you open a faucet. It does not store a large tank of hot water. The domestic water is heated as it flows through the unit, so the unit has no tank to refill.

Combi boilers save floor space and avoid a separate tank, which is why they are common in smaller homes. The trade-off is that the same heat source serves both loads. Running a shower while the heat is on can reduce how much hot water the unit delivers at one time, depending on its output and the flow rate at the fixture.

Because hot water is made on demand, a combi boiler behaves more like a tankless water heater than a storage tank. The federal test for tankless units uses a Maximum GPM rating, which is the maximum gallons per minute of hot water the unit can supply. Ask for that figure when you compare units, and ask how the unit performs when heating and hot water run at the same time.

Indirect water heaters: a storage tank heated by a boiler

An indirect water heater is a storage tank with a coil inside. Hot water from the boiler circulates through the coil, and the heat transfers to the potable water sitting in the tank. The boiler does the heating, and the tank holds the hot water until you need it.

This setup is common where a boiler already serves the radiators and the homeowner wants a tank for hot water. It keeps domestic water separate from the heating water, so the tank can be sized for household use. The boiler still has to run to reheat the tank, so hot water demand and heating demand share the same equipment.

Storage tanks, including indirect tanks, can allow Legionella bacteria to grow under certain conditions. The Department of Energy (DOE) recommends a tempering (mixing) valve set to 120°F downstream of storage tanks. Ask any pro who works on your system whether that valve is present and set correctly.

How to tell which one you have

You can usually identify the system with a few visual checks. Start with the heating side, then look at the hot water side. Do not open any panel or valve until you have read the safety notes below.

  1. Look for heat emitters. Radiators, baseboard fin-tube units or floor-tubing manifolds mean the home has hydronic heat, which is supplied by a boiler.
  2. Find the thermostat. A room thermostat wired to a boiler or furnace controls heating. A water heater normally has its own controls on the unit and no room thermostat.
  3. Look for a tank. A standalone storage water heater is a tank with a cold water inlet, a hot water outlet at the top and a drain valve near the bottom, usually with a temperature and pressure relief valve and its discharge pipe.
  4. Count the pipes on the tank. If a tank has two extra pipes connected to a boiler loop, it is an indirect water heater. A tank with only cold in and hot out is a standalone water heater.
  5. Look for a single unit with no tank. If one wall-mounted unit has a cold water supply, a hot water outlet and heating connections, and there is no storage tank, you likely have a combi boiler.
  6. Read the data label. The label on the unit usually names the fuel, the input rating and whether the unit is designed for heating, for water heating or for both.

If the labels are missing or the layout is unclear, the answer is usually in the installation records or the paperwork from the original install. A pro can confirm the system in a few minutes during a service visit.

Quick comparison of common setups

The table below shows what each setup does. It is a guide to the roles, not a recommendation for any specific home.

SetupHeats the homeMakes hot waterStorage tank
Standalone boilerYesNoUsually none
Standalone storage water heaterNoYesYes
Tankless water heaterNoYes, on demandNo
Combi boilerYesYes, on demandNo
Indirect water heater with boilerYes (via boiler)Yes, from the tankYes

Efficiency ratings and how long these systems last

Water heaters are rated by the Uniform Energy Factor (UEF), which is the measure of a water heater's overall efficiency under the federal test procedure. Higher numbers mean more efficient units. ENERGY STAR sets minimum UEF levels, including 0.86 for gas storage units over 55 gallons, 0.95 for gas tankless units and 3.30 for integrated heat pump water heaters.

According to the DOE, most storage (tank) water heaters last 10 to 15 years, while tankless water heaters can last more than 20 years. Those ranges apply to water heaters. Boiler life depends heavily on maintenance and water quality, so ask a pro to explain what to expect from your specific unit.

DOE efficiency standards have applied since April 16, 2015. A DOE final rule published May 6, 2024 requires, from May 6, 2029, that larger electric storage water heaters meet heat-pump-level efficiency. A separate DOE rule for gas tankless water heaters, dated December 2024, was withdrawn by Congress under the Congressional Review Act on May 20, 2025.

Temperature, gas and electrical safety

Safety first: If you smell gas, leave the home and call the gas utility or 911 from outside. Do not operate switches or appliances inside. For electric units, turn off the breaker and verify there is no power before you open any access panel. Set the water heater to 120°F to reduce the risk of scalding, and install carbon monoxide alarms on every level of the home and outside sleeping areas, as the CPSC recommends.

The Consumer Product Safety Commission (CPSC) says third-degree burns can occur after about 2 seconds at 150°F, 6 seconds at 140°F and 30 seconds at 130°F, and can even occur after 5 minutes at 120°F. The DOE says 120°F is a temperature considered safe for most of the population. People with a compromised immune system or chronic respiratory disease may want to keep the setting at 140°F, so check with your doctor before you change it.

Check the temperature setting on any unit that serves a home with children or older adults. Note that a combi boiler or indirect setup may have a separate control for domestic water, so confirm the setting on the correct control.

Replacement, rebates and tax credits

Federal tax credits change over time, so confirm the current status on the official IRS and DOE sites before you plan a purchase. As of November 19, 2026, the 25C Energy Efficient Home Improvement Credit applied only to property placed in service before December 31, 2025, so it does not apply to 2026 installations. The 25D Residential Clean Energy Credit, including for solar water heaters, is not available for property placed in service after December 31, 2025.

DOE Home Electrification and Appliance Rebates (HEAR) are run by states and available only in select states. They offer up to $1,750 for an ENERGY STAR heat pump water heater for households with income below 150% of area median income. Since DOE Program Notice 26-2, effective May 29, 2026, these rebates no longer cover replacing a gas (non-electric) appliance. Check your state energy office and your utility for current programs.

Prevention and everyday care

  • Keep the water heater set at 120°F unless a health condition calls for a different setting.
  • Confirm that any storage tank has a tempering valve set to 120°F downstream, as the DOE recommends.
  • Follow the maintenance steps in the manual, including periodic draining of sediment when the manufacturer calls for it.
  • Check the pressure relief valve discharge pipe for signs of dripping, and report any repeated discharge.
  • Keep the area around the boiler and water heater clear so service access is easy.

When to call a professional and how to choose one

Call a pro if you cannot identify the system, if a boiler loses pressure repeatedly, if a relief valve discharges steadily, or if you are considering a switch between a boiler, a combi and a storage tank. Any gas line work, venting change or electrical connection should be handled by a qualified contractor. Local rules differ, so check with your local building department before work begins.

Get at least two written quotes that list the same scope of work. Check the contractor's license with the state licensing board where licensing applies. Ask about permits and who pulls them, and ask what is included, such as haul-away of the old unit, any code upgrades and warranty registration.

Frequently asked questions

Can one unit heat my house and my hot water?

Yes, a combi boiler does both jobs from one unit. It heats water for radiators or baseboards and also heats tap water on demand, so it usually has no storage tank. Performance depends on the unit's output and on how many fixtures run at once. Ask a pro to explain how the unit handles heating and hot water at the same time before you buy.

Is a combi boiler the same as a tankless water heater?

They work in a similar way, since both heat water as it flows and do not store a large tank. The difference is that a combi also heats your home. Tankless units are rated by Maximum GPM, the maximum gallons per minute of hot water they can supply. Ask for that figure and the unit's heating output when comparing the two.

How can I tell if my water tank is an indirect water heater?

Look for two extra pipes connected to a boiler loop in addition to the cold inlet and hot outlet. If the boiler also serves radiators or baseboards, the tank is likely indirect. A standalone storage water heater has its own burner or elements and normally has no connection to a heating loop. A pro can confirm this quickly during a service visit.

Do boilers last as long as water heaters?

The DOE gives life ranges for water heaters: most storage tanks last 10 to 15 years, and tankless units can last more than 20 years. No comparable range applies to boilers in this guide. Boiler life depends on maintenance, water quality and how the unit was sized, so ask your pro what to expect for your model.

Can I replace a gas boiler with an electric water heater and get a rebate?

Rebates depend on your state, your utility and your income. Since DOE Program Notice 26-2 took effect on May 29, 2026, HEAR rebates no longer cover replacing a gas (non-electric) appliance, only electric-to-more-efficient-electric upgrades. Check your state energy office and utility for current programs, and confirm the details on the official DOE and IRS sites before you commit.

Who should size and install a replacement system?

A qualified contractor should size the system, because a boiler and a water heater must match the home's heating load and hot water use. Get at least two written quotes, check licensing with your state board where it applies, and confirm who pulls permits. Ask whether the price includes haul-away, code upgrades and warranty registration.

Need a pro? See businesses that install and repair water heaters in your metro area. Ask for at least two written quotes and check the contractor's license with your state where it applies.