The Water Heater Guide

Sizing & efficiency

ENERGY STAR Water Heaters: What the Label Means

Updated November 19, 2026By the The Water Heater Guide editorial team
ENERGY STAR Water Heater

An ENERGY STAR water heater is a model that meets minimum efficiency levels set for its type. Efficiency is measured by the Uniform Energy Factor (UEF), and a higher UEF means the unit is more efficient overall. The UEF on the yellow EnergyGuide label, checked against the ENERGY STAR minimum for that category, lets you compare models before you buy.

What an ENERGY STAR Water Heater Has to Meet

ENERGY STAR sets efficiency criteria for specific water heater categories, and each category has its own minimum UEF. A unit that does not reach the minimum for its category does not qualify, even if it uses less energy than an older model of the same type.

The categories covered in this guide are integrated heat pump water heaters, gas storage (tank) units, gas tankless units, and solar water heaters. For other types, look up the current ENERGY STAR listing for that category and compare the UEF printed on the label.

Uniform Energy Factor Explained

The Uniform Energy Factor is defined in the federal test procedure at 10 CFR 430, Appendix E. It is the measure of a water heater's overall efficiency. In practical terms, it reflects how much energy the unit uses to deliver hot water across a standard pattern of use, including the energy lost while the unit sits on standby.

UEF tells you how efficiently a unit works, but it does not tell you whether the unit is big enough. Two related ratings from the same federal test procedure cover capacity: the First-Hour Rating for storage tanks and the Maximum GPM for tankless units. You need both the efficiency number and the capacity number to make a good choice.

Compare UEF mainly within the same type and fuel. A heat pump and a gas tank use different technology, so a higher UEF on one does not automatically mean it is the better fit for your home. Installation space, local fuel prices, and how much hot water your household uses all matter too.

ENERGY STAR Minimum UEF by Category

Use this table as a starting point. Within a category, a higher UEF means a more efficient unit.

CategoryENERGY STAR minimum UEF
Integrated heat pump water heater3.30 (split-system or 120-volt units: 2.20)
Gas storage, over 20 and up to 55 gallons0.81 (medium draw) or 0.86 (high draw)
Gas storage, over 55 gallons0.86
Gas tankless0.95
Solar with electric backup3.00
Solar with gas backup1.80

For gas storage units in the 20 to 55 gallon range, the draw level matters. Medium-draw models suit households with moderate hot water needs, while high-draw models are rated for homes that run several fixtures at once. Check the label or the product listing to confirm which draw category applies to the model you are considering.

How to Read the EnergyGuide Label

The EnergyGuide label is the yellow tag attached to many new water heaters. It shows an estimated yearly operating cost for that model and a comparison with similar units. Use it together with the ENERGY STAR listing, not as a replacement for it.

  1. Find the UEF. Locate the efficiency rating and confirm it meets or beats the ENERGY STAR minimum for that category.
  2. Confirm the type and fuel. Make sure the label matches what you plan to buy: storage tank, tankless, heat pump, or solar, and electric or gas.
  3. Read the estimated yearly cost. Compare this figure only between models of the same type and fuel. It is based on standard test conditions, so it will not match your actual bill exactly.
  4. Look at the comparison scale. Note where the model falls relative to similar units so you can see how it ranks.
  5. Check the capacity rating. For a tank, look for the First-Hour Rating. For a tankless unit, look for the Maximum GPM. An efficient unit that is too small will leave you short of hot water.
  6. Match the model number. Compare the model number on the label with the ENERGY STAR product listing before you rely on the rating.

Safety First: Gas Units and Their Vents

If you smell gas near a gas-fired water heater or its vent, leave the home and call the gas utility or 911 from outside. Do not try to test the appliance or operate its controls while you smell gas. The Consumer Product Safety Commission (CPSC) recommends carbon monoxide alarms on every level of the home and outside sleeping areas, so check that yours are working.

Matching Efficiency to the Right Size

An efficient unit only saves energy if it can meet your demand. For a storage tank, compare your household's peak-hour hot water demand with the First-Hour Rating on the label, not with the tank's gallon capacity. The First-Hour Rating estimates the maximum volume of hot water the unit can supply within an hour, starting fully heated.

For a tankless unit, sizing depends on two numbers. Required flow is the sum of the fixtures used at the same time, measured in gallons per minute (GPM). Temperature rise is your desired hot water temperature minus the incoming water temperature.

  1. List the fixtures that often run at the same time, such as a shower and a dishwasher.
  2. Add their flow rates to get the required flow. Federal maximums are 2.5 GPM for showerheads at 80 psi and 2.2 GPM for lavatory and kitchen faucets at 60 psi, which give you a reasonable upper estimate for older fixtures.
  3. Subtract the incoming water temperature from your target temperature to get the temperature rise.
  4. Compare both numbers with the unit's Maximum GPM and its stated temperature rise performance.

Common Mistakes When Comparing Labels

  • Buying on UEF alone. A high UEF does not help if the unit cannot keep up with your peak hour.
  • Comparing across types. A heat pump, a gas tank, and a tankless unit have different ratings and different installation needs.
  • Ignoring the draw category. Gas storage models in the same size range can have different minimums depending on draw.
  • Treating the yearly cost as a bill. The EnergyGuide figure is a comparison tool, not a forecast of what your utility will charge.
  • Skipping the installation details. Venting, electrical capacity, and space requirements can change the real cost of a model.

Keeping an Efficient Water Heater Working Well

According to the U.S. Department of Energy (DOE), water heating is about 18% of a home's energy use, so the setting and the unit's condition both matter. The DOE describes 120°F as a temperature considered safe for most of the population. People with a compromised immune system or chronic respiratory disease may want to keep the setting at 140°F.

According to the DOE, most storage (tank) water heaters last 10 to 15 years, while tankless water heaters can last more than 20 years. A rating helps you choose a unit, but regular inspection and timely repairs help it perform the way it was rated.

Checking Incentives Before You Buy

Incentives change, so confirm current details on the official source before you commit. According to the IRS, the 25C Energy Efficient Home Improvement Credit allowed up to $2,000 a year for heat pump water heaters and up to $600 for qualifying gas, propane or oil water heaters. It applied only to property placed in service before December 31, 2025, so it does not apply to 2026 installations.

The 25D Residential Clean Energy Credit, which was 30% and included solar water heaters, is not available for property placed in service after December 31, 2025. These figures were checked on official sources on November 19, 2026, so confirm the current rules on IRS.gov before you plan around any credit.

DOE Home Electrification and Appliance Rebates (HEAR) are run by states and are available only in select states. They offer up to $1,750 for an ENERGY STAR heat pump water heater for households with income below 150% of area median income. Since DOE Program Notice 26-2, effective May 29, 2026, these rebates no longer cover replacing a gas (non-electric) appliance, so only electric-to-more-efficient-electric upgrades qualify. Check your state energy office and your utility's website, because utility rebates vary.

Finding a Pro for the Installation

Get at least two written quotes so you can compare the scope, not just the total. Check the contractor's license with the state licensing board where licensing applies. Ask who pulls the permit, and check with your local building department about which permits and inspections your city or county requires, since rules vary by location.

Ask each bidder what is included: haul-away of the old unit, any code upgrades, venting or electrical work, and whether they will register the warranty for you. A lower quote that leaves these items out may cost more once the job is finished.

Frequently Asked Questions

Does a higher UEF always mean a lower energy bill?

A higher UEF means the unit is more efficient overall, so it uses less energy to deliver the same hot water. Your actual bill also depends on local energy prices, how much hot water your household uses, the temperature you set, and how the unit is installed. Compare units of the same type and fuel, and treat the EnergyGuide estimate as a rough comparison rather than a forecast of your bill.

Can I still claim the 25C credit on a water heater installed this year?

According to the IRS, the 25C credit applied only to property placed in service before December 31, 2025, so it does not apply to 2026 installations. The 25D credit, which included solar water heaters, is also unavailable for property placed in service after that date. Confirm current rules on IRS.gov or with a tax professional before assuming any credit applies to your purchase.

Do rebates depend on where I live?

Often they do. HEAR rebates are run by states and are available only in select states, and utility rebates vary by provider. Check your state energy office and your utility's website for current programs. The HEAR heat pump rebate is limited to households below 150% of area median income and no longer covers replacing a gas appliance.

How long can I expect an efficient water heater to last?

According to the DOE, most storage tank water heaters last 10 to 15 years, and tankless units can last more than 20 years. UEF measures efficiency, not lifespan, so a high-efficiency tank still falls within the tank range. Keeping the unit inspected and sized correctly for your household helps it perform as rated for as long as it lasts.

What should I do if my current water heater is too small?

For a tank, compare your peak-hour demand with the First-Hour Rating on the label. For a tankless unit, compare your simultaneous fixture flow in GPM with the Maximum GPM. If the numbers fall short, you may need a larger unit or a different type. Ask each installer to show the sizing calculation in writing before you accept a quote.

Need a pro? See businesses that install and repair water heaters in your metro area. Ask for at least two written quotes and check the contractor's license with your state where it applies.