What does UEF mean on a water heater?
A uniform energy factor (UEF) is the federal efficiency rating listed for a water heater. It measures the unit's overall efficiency under a standard daily hot water use pattern. Higher numbers mean a more efficient unit, and the figure lets you compare models on the same scale.
How the Number Is Measured
The U.S. Department of Energy defines the uniform energy factor under the federal test procedure in 10 CFR 430, Appendix E. The test looks at how much energy the unit uses over a full day of hot water draws, not just at its peak output. That is why the rating works across storage, tankless and heat pump units.
UEF is not a direct dollar cost. Your actual bill depends on your fuel prices, your local climate and how much hot water your household uses. Use UEF to compare units of the same type, such as two gas storage tanks, rather than mixing electric heat pumps with gas tankless units.
What the Rating Looks Like in Practice
ENERGY STAR sets minimum UEF levels that a unit must meet to qualify. These are the current minimums for common types:
- Integrated heat pump water heaters: 3.30 (split-system or 120-volt units: 2.20)
- Gas storage, over 20 and up to 55 gallons: 0.81 (medium draw) or 0.86 (high draw)
- Gas storage, over 55 gallons: 0.86
- Gas tankless: 0.95
- Solar water heaters: 3.00 with electric backup, or 1.80 with gas backup
A number above the minimum means the unit meets the efficiency bar for its category. It does not tell you whether the unit has enough capacity for your home, so check sizing separately.
How to Check a Unit's Rating and Fit
- Find the UEF on the label or the manufacturer's specification sheet for the exact model number.
- Confirm the fuel type and tank or tankless design, and compare only with units in the same category.
- Check the ENERGY STAR minimum for that category to see whether the unit qualifies.
- For a tank, compare your household's peak-hour hot water demand with the unit's First-Hour Rating, which is the estimate of the maximum hot water it can supply within an hour starting fully heated. Do not compare it with the tank's gallons.
- For a tankless unit, check the Maximum GPM against the required flow, which is the sum of the fixtures used at the same time in gallons per minute. Then confirm the temperature rise, which is your desired hot water temperature minus the incoming water temperature.
- Ask your installer to confirm the sizing calculation in writing before you buy.
Rebates and Credits Can Change the Math
Federal tax credits have changed. According to the IRS, the 25C Energy Efficient Home Improvement Credit applied only to property placed in service before December 31, 2025, so it does not apply to 2026 installations. The 25D Residential Clean Energy Credit, which included solar water heaters, is not available for property placed in service after December 31, 2025.
DOE Home Electrification and Appliance Rebates are run by states and are available only in select states. They offer up to $1,750 for an ENERGY STAR heat pump water heater for households with income below 150% of area median income. Since DOE Program Notice 26-2 (effective May 29, 2026), these rebates no longer cover replacing a gas appliance, only electric-to-more-efficient-electric upgrades. Utility rebates vary, so check your utility's website. These facts were checked on November 19, 2026, so confirm current details on the official sites.
Checklist Before You Buy
- Write down the UEF, fuel type and category for each unit you are considering.
- Confirm the unit meets the ENERGY STAR minimum for its category.
- Compare First-Hour Rating or Maximum GPM with your actual peak demand.
- Check whether your state energy office or utility offers a current rebate, and whether your situation qualifies.
- Get at least two written quotes, and check the contractor's license with the state licensing board where licensing applies.
- Ask who pulls the permit, and check with your local building department on code requirements, since rules vary by state and city.
- Ask what the quote includes, such as haul-away of the old unit, any code upgrades and warranty registration.