Should I turn off my water heater if it's leaking?
Yes, in most cases you should turn off a leaking water heater. Shut off the power (the breaker for electric units or the gas control for gas units) and close the cold water supply valve at the top of the tank. This stops the heater from heating more water and limits damage while you look for the source.
Find where the water is coming from
Before you change anything, figure out which part is leaking. Water can come from the cold inlet or hot outlet fittings, the drain valve at the bottom, the temperature and pressure (T&P) relief valve, or the tank itself. Fittings and drain valves are sometimes repairable by a pro, but a leak through the tank wall usually means the heater needs replacing.
The relief valve needs a closer look. Its discharge pipe should run down to an air gap in the same room, end no more than 6 inches above the floor or a waste receptor, and never be capped, plugged, trapped or threaded. A relief valve that drips now and then may be reacting to high pressure, while steady discharge is a sign to shut the unit down and call a pro. Never plug the valve or its pipe to stop the drip.
Check the age of the unit too. According to the U.S. Department of Energy, most storage (tank) water heaters last 10 to 15 years. If yours is near or past that range, replacement is often a better choice than a repair.
Shut off the heater safely
Safety first: If you smell gas, leave the home and call the gas utility or 911 from outside. Do not switch lights or appliances on or off on the way out. For electric units, confirm the power is off with a voltage tester before you touch the wiring or controls.
- Switch off the breaker that feeds the water heater, then test at the unit to confirm the power is off.
- For a gas unit, turn the gas control knob to 'Pilot' or 'Off' as marked on the unit.
- Close the cold water supply valve on the pipe feeding the top of the heater by turning it clockwise.
- Open a hot tap elsewhere in the house to relieve pressure and let air into the system.
- Attach a garden hose to the drain valve at the bottom and run it to a floor drain or outdoors. Open the valve to drain the tank, and let the water cool first if it is hot. Scalding is a real risk, so keep children and pets away.
- Photograph the leak and note the unit's age and location before you call for help.
When you restore service, set the thermostat to 120°F. According to the U.S. Department of Energy, 120°F is a temperature considered safe for most of the population, and the U.S. Consumer Product Safety Commission notes that third-degree burns can occur after about 5 minutes at 120°F.
When to call a pro and what to ask
Call a plumber or water heater technician for any leak from the tank, steady discharge from the relief valve, or a leak at a fitting you cannot tighten safely. A pro can also check whether the leak points to a pressure or expansion problem that will affect a new unit.
Get at least two written quotes and check the contractor's license with your state licensing board where licensing applies. Ask who pulls the permit, since rules for relief valve piping and water heater replacement vary by state and city, so check with your local building department. Ask what the quote includes, such as haul-away of the old unit, code upgrades and warranty registration.
Checklist
- Cut power or gas to the heater before doing anything else.
- Close the cold water supply valve and drain the tank if the leak continues.
- Leave the relief valve and its discharge pipe unplugged and uncapped.
- Check the unit's age against the 10 to 15 year typical range.
- Get at least two written quotes and confirm permits and included work before you hire.