The Water Heater Guide

Is it normal for a water heater to make noise?

Some water heater noise is normal. A tank that pops, ticks or rumbles is usually reacting to sediment on the bottom or to metal expanding as it heats. Loud banging, hissing that won't stop, or water dripping from the relief valve needs prompt attention.

Common noises and what usually causes them

  • Popping, crackling or rumbling: Minerals from hard water settle on the tank floor. Water trapped under that layer overheats, and steam bubbles burst through as the burner or element runs. This gets louder as sediment builds up over time.
  • Ticking or pinging: Tank walls and pipes expand when heated and contract as the water cools. Quiet ticking during heating and cooling cycles is generally harmless.
  • Banging in the pipes: This is usually water hammer, a shock wave when a valve or appliance shuts off quickly. The sound comes from the plumbing rather than the tank.
  • Whistling or hissing: A partly closed valve, a clogged faucet aerator or a small leak can force water through a tight opening. Steady hissing at the tank or the relief valve deserves a closer look.
  • Roaring or booming on gas models: A steady burner roar is normal. A loud boom when the burner lights suggests delayed ignition, which needs a pro to diagnose.

Gas water heaters made after July 1, 2003 are built to a flammable vapor ignition resistant (FVIR) standard, according to the Consumer Product Safety Commission (CPSC). Never store gasoline or solvents near a gas water heater.

What to check safely

Start with the simple checks below before you open any panels.

  1. Note the sound. Write down when it happens, such as during heating, when a faucet runs, or all the time.
  2. Check the temperature setting. The U.S. Department of Energy (DOE) recommends 120°F as a temperature considered safe for most of the population. Higher settings raise the scald risk, and the CPSC notes third-degree burns can occur after about 2 seconds at 150°F.
  3. Inspect the relief valve discharge pipe. According to the International Plumbing Code 504.6 and International Residential Code P2804.6.1 (2021 editions), the pipe should drain by gravity into an air gap in the same room. It must not be trapped, must be no smaller than the valve outlet, must end no more than 6 inches above the floor or a waste receptor, and must have no threads, valves or tees. Never cap or plug the valve. Check with your local building department for local rules.
  4. Look for leaks. Dry a section of the tank base, fittings and drain valve with a paper towel, then check for moisture after an hour.
  5. Check the age. According to the DOE, most storage tank water heaters last 10 to 15 years, while tankless units can last more than 20 years. A noisy tank near or past that range may be nearing the end of its service life.

Safety first: If you smell gas near a gas water heater, leave the home and call the gas utility or 911 from outside. Do not operate switches or appliances on the way out.

Flushing a tank can reduce sediment popping, but it means draining hot water, so follow the unit's instructions and let the water cool first. If you need to reach an electric element access panel, turn off the breaker and verify the power is off with a voltage tester before you touch anything.

When to call a professional

  • Banging or booming that gets louder or continues after you adjust the temperature
  • Water dripping or spraying from the relief valve, or the valve discharging repeatedly
  • Water pooling around the base of the tank
  • Rusty or discolored water along with new noises
  • A tank older than the 10 to 15 year range

When you hire someone, get at least two written quotes. Check the contractor's license with the state licensing board where licensing applies, ask whether permits are needed and who pulls them, and ask what is included, such as haul-away, code upgrades and warranty registration.

Checklist

  1. Record the sound, its timing and what triggers it.
  2. Confirm the thermostat is set to 120°F.
  3. Verify the relief valve discharge pipe meets the rules above and is not capped.
  4. Check for drips and wet spots at the tank base and fittings.
  5. Compare the unit's age with the 10 to 15 year range.
  6. Call a pro if the noise is loud or growing, or if it comes with leaks or valve discharge.

Read the full guide →