Can a water heater explode?
Yes, a water heater can explode, but it is uncommon. The main danger is a tank that builds up pressure or heat with no way to release it, usually because the temperature and pressure relief valve is faulty, blocked or missing its discharge pipe. Gas units can also ignite flammable vapors nearby.
What causes a water heater to explode
A storage tank holds water at high temperature, and heated water takes up more space than cold water. When the tank has nowhere to send that extra pressure, the walls and fittings are pushed past their limits. The temperature and pressure relief valve is the safety device meant to open and release that pressure before it becomes dangerous.
Several conditions make that failure more likely. A relief valve that is stuck, corroded or plugged cannot open. A thermostat set too high pushes the tank hotter than it needs to be. Sediment on the bottom of the tank can insulate the water from the burner or element, which makes the tank work harder and overheat.
Tank age matters too. According to the U.S. Department of Energy, most storage (tank) water heaters last 10 to 15 years. A tank past that range is more likely to have corrosion, weak fittings and valves that no longer seat properly.
Check the relief valve and discharge pipe
The relief valve and its discharge pipe are the parts most worth checking. Under the International Plumbing Code (section 504.6) and the International Residential Code (section P2804.6.1), 2021 editions, as summarized by the International Code Council, a discharge pipe must meet these rules:
- It must not connect directly to the drainage system.
- It must end in an air gap in the same room as the water heater.
- It must not be smaller than the valve outlet.
- It must not be trapped, and it must drain by gravity.
- Its end must be no more than 6 inches above the floor or a waste receptor.
- It must have no threaded end, valves or tees.
- The pipe and valve must be rated for 100 psi at 180°F.
A relief valve must never be capped or plugged. Requirements can vary by state and city, so check with your local building department for the rules that apply to your home.
Gas units and flammable vapors
Gas water heaters can ignite flammable vapors from gasoline, solvents or paint thinners stored nearby. The CPSC has linked gas water heaters that ignite flammable vapors to about 800 fires a year. Gas water heaters made after July 1, 2003 (30, 40 and 50 gallon tank models) are built to a flammable vapor ignition resistant (FVIR) standard, which lowers that risk, but storage habits still matter.
Safety first: If you smell gas, leave the home right away and call the gas utility or 911 from outside. Do not turn lights or appliances on or off, and do not use a phone inside the building.
Scalding is a separate risk from explosion. The CPSC says third-degree burns can occur after about 2 seconds at 150°F, 6 seconds at 140°F, 30 seconds at 130°F and 5 minutes at 120°F. The CPSC recommends setting water heaters to 120°F, which the DOE also describes as a temperature considered safe for most of the population.
Quick safety checklist
- Confirm the temperature setting is 120°F or lower, unless a household member has a compromised immune system or chronic respiratory disease and needs 140°F.
- Look at the relief valve. It should not be capped, plugged, corroded or dripping constantly.
- Follow the discharge pipe from the valve to where it ends. Confirm it runs downward, stays open to the air and ends within 6 inches of the floor or a waste receptor.
- Keep gasoline, solvents and other flammable materials away from a gas water heater.
- Note the tank's age. A tank near or past 10 to 15 years deserves a professional inspection.
- Call a professional right away if you see a bulging tank, rumbling or popping sounds, water pooling at the base, or rust-colored or foul water.
- If you plan repairs or replacement, get at least two written quotes, check the contractor's license with your state licensing board where licensing applies, ask who pulls the permits, and ask what is included, such as haul-away, code upgrades and warranty registration.